For copper connections where a torch is not safe or practical. We use it in tight wall cavities and near framing where open flame is a bad idea.
Bathroom Remodeling Plumbing in lancaster done right the first time
Bathroom Remodeling Plumbing in lancaster means tearing into walls, moving supply and drain lines, and putting it all back so it holds for decades.
Serving lancaster and nearby areas.
How big is the bathroom plumbing job?
Full rough-in
New supply and drain lines for a gut remodel with fixtures staying in place.
- 1. Fixture swap Replacing a toilet, faucet, or shower valve on existing rough-in.
- 2. Full rough-in New supply and drain lines for a gut remodel with fixtures staying in place.
- 3. Relocation Moving fixtures, adding a second sink, or repiping old lines. Planned in writing first.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 15Areas served around lancaster
- Camera firstWe inspect the drain before tying in new fixtures.
- Pressure testSupply lines charged overnight before walls close.
What our Bathroom Remodeling Plumbing service includes
The plumbing scope on a bathroom remodel covers everything from the supply stub to the drain tie-in.
Work order
Bathroom Remodeling Plumbing- Permit and inspection: We file the local plumbing permit, schedule the rough inspection, and meet the inspector on site. You do not have to be home for it. If the inspector flags something, we fix it and re-schedule without charging you extra.
- Supply line rough-in: New PEX or copper runs from the existing trunk to every fixture location. We size the lines for the fixtures you picked, install shutoff valves at each stub, and pressure-test at 100 psi before the walls close.
- Drain and vent tie-in: We cut out the old drain, set the new shower pan drain and toilet flange, and tie everything back into the existing stack. If the vent needs to be re-routed, we handle that as part of the rough-in.
- Fixture set and trim: After tile and paint, we set the toilet, vanity, shower valve trim, tub spout, and faucets. Every supply connection gets tested and every drain gets run before we call it done.
- Old pipe removal: If the remodel uncovers failing galvanized or cast iron, we cut it out and haul it away. We will tell you upfront if a partial repipe makes more sense than patching into old pipe.
- Final test and walkthrough: We run hot and cold at every fixture, check for leaks at the stops and drain connections, and confirm water pressure at the shower head. You get a walkthrough and a written list of what was installed.
What the first visit covers
First visit
We walk the bathroom, check the existing supply and drain, confirm venting, and scope the rough-in and finish work.
Bathroom plumbing for Lancaster homes
From a single vanity swap to a full master bath gut, we handle the plumbing scope.
Hall bath gut
New rough-in, valve, and drain tie-in.
Master bath addition
Supply, drain, and venting for new fixtures.
Basement bath
Drain tie-in and sump pump check.
Fixture relocation
Moving a toilet, shower, or vanity.
Bathroom plumbing for Lancaster businesses
Restroom rough-ins and fixture upgrades for small commercial spaces in and around Lancaster.
Office restrooms
ADA-compliant rough-in and fixture set.
Retail spaces
Backflow prevention and supply upgrades.
Restaurant bathrooms
Drain cleaning and fixture replacement.
What Bathroom Remodeling Plumbing in lancaster actually involves
The plumbing behind a bathroom wall is the one part you cannot easily fix later. Getting the rough-in right, pressure-tested, and code-correct the first time costs less than tearing out new tile to chase a leak.
Bathroom Remodeling Plumbing in lancaster is the rough-in and finish work behind every wall, floor, and fixture in a bathroom renovation. That means cutting out old galvanized or copper supply lines, running new PEX piping through joists, tying a new shower drain into the existing stack, and setting a wax ring and flange that will not leak. We pull the local plumbing permits, coordinate with your tile and drywall crews, and pressure-test every line before the walls close.
Most homeowners call us when a bathroom remodel plumber Lancaster Ohio contractors quoted has gone sideways, or when they realize the old drain lines under a 1920s house on Pleasant Run cannot handle a modern shower valve. We also handle bathroom plumbing rough in Lancaster for additions and basement baths. If you are searching for a bathroom remodel plumber near me Lancaster OH, we can walk the space, scope the work, and give you a written number the same week.
- What it is
- Rough-in and finish plumbing for a bathroom remodel.
- When it helps
- Gut remodels, additions, fixture moves, and old pipe replacement.
- What you get
- Permitted, pressure-tested plumbing that passes inspection.
How our bathroom plumbing remodel works
We keep the plumbing schedule tight so your contractor can keep moving.
Tools and methods we use on bathroom plumbing jobs
Each method answers a different question. Together they leave very little to guess.
Clean, square cuts on copper and PEX. A square cut is the difference between a fitting that seals and one that weeps after a year.
We check static and dynamic pressure at the main before sizing supply lines. If the incoming pressure is low, no fixture will fix it.
We camera the drain and stack before rough-in to check for cracks, root intrusion, or bellies. Knowing the condition upfront prevents surprises after the floor is set.
For heavy scale or grease buildup in an existing drain line. We jet the line clean before tying in new fixtures so the new shower drains fast from day one.
When to call us for Bathroom Remodeling Plumbing in lancaster
You are gutting a hall bath in a 1950s Lancaster home and the existing supply lines are galvanized.
We demo the old pipe, run new PEX from the trunk line, set a new shower valve and drain, and pressure-test before…
HomesYou are adding a master bath in a Cherry Hill addition and need to tie into the existing stack.
We scope the venting, confirm the stack can handle the added load, run the new drain and supply lines, and coordinate with…
HomesYour basement bath has a sump pump and you want to finish the space without water problems.
We check the sump pump and check valve, run the drain to the existing line, and install a backflow assembly if the…
HomesYou are doing a kitchen and bath remodel at the same time and want one plumbing crew.
We handle both scopes on one schedule, run the rough-in for both rooms in the same phase, and book a single inspection.
Homes and businesses
How Bathroom Remodeling Plumbing runs in Lancaster
Lancaster has a mix of housing stock that changes how a bathroom remodel gets done. In Lancaster Old Town and Downtown Lancaster, you are often working in pre-1950 homes with galvanized supply lines and cast iron drains.
Lancaster Old Town
Pre-1950 homes with galvanized supply and cast iron drains. Most remodels here need a partial repipe while the wall is open.
Cherry Hill
Newer construction with PEX or copper already in place. Main issue is undersized supply for a rain shower and double vanity.
Pleasant Run
Older homes where the main drain often has root intrusion. We camera the line before tying in new fixtures.
- Lancaster Old Town
- Cherry Hill
- Pleasant Run
- Millersport
- Downtown Lancaster
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
Photo1928 hall bath repipe and rough-in
Before: A 1928 hall bath in Lancaster Old Town with galvanized supply lines that crumbled during demo. The drain was slow, the toilet rocked, and the shower valve was original. The wall was open and the homeowner was without water to that bathroom.
After: We repiped the supply run in PEX, set a new shower valve and pan drain, replaced the toilet flange, and pressure-tested at 100 psi overnight. The rough-in passed inspection on the first visit and the final fixture set took half a day.
Master bath addition in Cherry Hill
Before: A Cherry Hill homeowner added a master bath over the garage and needed to tie into the existing stack. The original supply lines were undersized for a rain shower and double vanity, and the venting had to be confirmed before framing closed.
After: We scoped the venting, ran new PEX supply lines sized for the fixtures, tied the drain into the stack, and coordinated with the framer so the rough-in lined up. The rough-in took three days and the final set took half a day.
Basement bath with root intrusion fix
Before: A Pleasant Run homeowner wanted to finish a basement bath, but the existing drain was slow and gurgled. A camera inspection found root intrusion in the main line before any rough-in work started.
After: We cleared the root intrusion, hydro jetted the line, and confirmed with a second camera pass. Then we ran the new drain and supply lines, installed a sump pump check valve, and tested the pump before the floor went down.
Problems our Bathroom Remodeling Plumbing in lancaster solves
Most bathroom remodels start because something is already wrong.
Old galvanized supply lines that crumble during demo
Once you open the wall, the pipe fails and you are without water to that bathroom until it is replaced.
Slow or gurgling drain that backs up after a shower
A drain that gurgles is usually a venting problem or a partial clog.
Low water pressure at the shower when the sink runs
Undersized supply lines or a failing pressure regulator cause this.
Toilet flange cracked or set below the finished floor
A flange that sits too low will not seal against the wax ring, and you get a slow leak at the base that rots the subfloor.
Why homeowners hire us for the plumbing side
A bathroom remodel lives or dies on what is behind the tile. Get the rough-in right and the rest of the job is easy.
Code-correct rough-in
Every drain, vent, and supply line we install meets Ohio plumbing code and passes Fairfield County inspection the first time.
One crew, no finger-pointing
We handle the bathroom plumbing rough in Lancaster and the final fixture set, so there is no gap between the rough plumber and the…
Old-house experience
Lancaster has a lot of pre-1950 housing stock with galvanized supply lines and cast iron drains.
Fast turnaround on the rough
A standard hall bath rough-in takes one to two days once demo is done.
What you get on the job
Clear records you can keep and share.
Written scope
Rough-in and finish work broken out separately.
Pressure test record
Supply lines charged overnight before close-up.
Camera findings
Drain and stack condition documented before rough-in.
16 years of bathroom plumbing in Fairfield County
Lancaster Hocking Flow Plumbing has been doing bathroom plumbing remodel work in Lancaster since 2010.
Drain camera
We read the line for cracks, root intrusion, or bellies before tying in new fixtures.
Pressure gauge
We check static and dynamic pressure at the main to size supply lines correctly.
Vent layout
We trace the vent back to the stack to confirm a relocated fixture will still drain properly.
Is your Lancaster area covered?
Type your ZIP code or town to check. If you are just outside our list, call and ask.
lancaster ZIP codes
- 43130
Towns we serve.
Based in lancaster and covering the places around it. Pick one for local details.
What Lancaster homeowners say
We gutted a 1928 bathroom and the original galvanized lines crumbled the second demo started. The crew repiped the whole run in PEX and had the rough-in done in two days. Inspector passed it first visit. They coordinated with our tile guy so nothing sat waiting. That alone was worth the price.
We moved the toilet and added a second sink in the master bath. I was worried the vent would not work, but they checked it before cutting anything and told us straight what was possible. Rough-in took three days, final set took half a day. No leaks, no callbacks, and the pressure is better than the old bathroom ever was.
Our hall bath drain was slow for years. They cameraed the line before rough-in and found root intrusion in the main. Fixed that first, then did the remodel plumbing. Cost more than the original quote, but they showed me the camera footage and explained why. Fair enough. Shower drains fast now.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(740) 766-4111A simple fixture swap on existing rough-in sits at the low end. Relocating a toilet, adding a second sink, or repiping a 1920s galvanized system pushes toward the top. That number does not include tile, drywall, or the fixtures themselves.
You can legally swap a faucet or reset a toilet yourself. Once you cut into the drain system or relocate a shower valve, it is a permitted job and it needs to be inspected. We handle both the permit and the inspection.
The rough-in phase takes one to two days for a standard hall bath and two to four days for a master bathroom remodel plumbing Lancaster Ohio job with relocated fixtures. After that, the plumbing sits idle while drywall and tile go in, usually two to three weeks. The final fixture set and test takes about half a day. Total plumbing time on site is typically three to five working days spread across the project.
Yes. Moving a toilet, shower, or vanity is one of the most common reasons people call us. The limit is the drain slope and the vent stack. A toilet needs a 2-inch drain at quarter-inch-per-foot fall, and the vent has to tie back to the existing stack. In most Lancaster homes we can relocate fixtures within the same room. Moving a bathroom to a different part of the house is a bigger job and we will tell you straight if it is worth it.
Related Services
Other services from the same team.
- Kitchen Remodeling PlumbingRelocating a sink under a window, adding a pot filler, or upgrading to a farmhouse sink.
- Repiping ServicesGalvanized steel and polybutylene lines in older Lancaster homes restrict flow and leak at joints.
- Fixture InstallationNew faucet, toilet, shower trim, or a whole bathroom set.
Get your Bathroom Remodeling Plumbing in lancaster scheduled
(740) 766-4111We give you a written scope, a real start date, and a crew that shows up.
contact Lancaster Hocking Flow Plumbing
Call us at (740) 766-4111 or send an email to [email protected]. We answer the phone during business hours and return after-hours messages first thing the next morning. For emergencies, call and follow the prompt. We serve all of Lancaster and Fairfield County.